To Next Page

To Previous Page

Specifying the E-mail Sender

This section explains how to specify the e-mail sender.

To send e-mail, you must specify the name of the sender.

You can specify the e-mail sender by any of the following methods:

• Select the sender from the sender list

• Select the sender by entering the registration number

• Select the sender by searching the machine’s address book

Note

❒ Senders must be registered in advance under [System Settings]. For details, see

General Settings Guide.

❒ In [System Settings], you can specify the administrator’s e-mail address as the

default sender name. This lets you send e-mail without entering anything for

[Sender Name]. For detail, see General Settings Guide.

❒ Depending on the security setting, the logged-on user may be specified as

[Sender Name].

❒ When a protection code has been set, a screen for entering the protection code

appears after selecting the sender. Enter the protection code, and then press

[OK]. If the protection code you entered is correct, the sender name is dis-

played.

Selecting a Sender from the List

This section explains how to select the sender from the machine’s sender list.

A Press [Sender Name].

B Select the sender.

C Press [OK].

Ricoh Scanner Scanner Guide

Other manuals for Ricoh Scanner