Configuring the Administrator Settings
Click [Administrator Tools] to display the page for configuring the administrator settings.
This page contains the following tabs: [Administrator], [Reset Settings], [Backup Setting], [Restore
Setting], [Set Date/Time], and [Energy Saver Mode].
This page contains the following tabs: [Administrator], [Reset Settings], [Backup Setting], [Restore
Setting], and [Help Source File Setting].
Administrator Tab
Administrator Settings
Item Description
Change
Password
Check this to configure the administrator password.
New Password Enter the new administrator password. Can contain up to 16 characters.
Confirm New Password Enter the same password again, to confirm.
Change E-mail
Address
Check this to configure the administrator e-mail address.
Administrator E-
mail Address
Enter the administrator e-mail address.
If the machine's e-mail address is not configured in the [SMTP] page,
this address will be used as the sender's address of e-mails sent from this
machine, such as notification e-mails. Can contain up to 64 characters.
Reset Settings Tab
Reset Settings
Item Description
Reset Network Settings Select to restore settings configured under the [Network Settings] and
[Administrator Tools].
Reset Menu Settings Select to restore settings that are not related to the network to their defaults.
Clear Scan
Destination
Select to clear the scan destinations.
Configuring the Administrator Settings
opal-p2_mf2_com_user_guide_00142140_eng.xml 193
To Next Page
Loading...
Need help?
General
