9
PRODUCT DESCRIPTION
2.7 Identication
The products are identied by:
Fig. 2
120 V
-
60 Hz less than 3
Amperes
Serial number:
Made in
Italy
Certified by RIELLO S.p.a.
Via Nazionale 56/A
65010 Villanova di Cepagatti (PE) Italy
Design to
ANSI
Z21.13-2017
CSA 4.9-2017
Hot Water Boiler
DIRECT VENT BOILER FOR EITHER DIRECT VENT
INSTALLATION OR FOR INSTALLATION USING
INDOOR COMBUSTION AIR
Category
Model no.
IV
Part
no.
Equipped for Natural
gas
Min. inlet gas
pressure
Max. inlet gas
pressure
Manifold
pressure
Min. input
rate
Max. input
rate
Output
rate
Min. relief valve
capacity
Altitude*
in.W.C.
in.W.C.
factory set - not adjustable
kW
Btu/hr
kW Btu/hr
kW Btu/hr
kg/h r
lbs/hr
CRN
no ,
W8206.2CL
m
ft
(*for installations above 2,000 ft, refer to installation manual)
Data plate
This lists the technical specications and performance of the
product. This is supplied inside the document bag and MUST BE
APPLIED to the boiler by the installer on completion of instal-
lation. If you damage or lose this label, order a replacement
immediately from your local
R boiler representative.
Data plate
9
NOTE: If these plates or any other means clearly identifying the
product are defaced, removed or lost, proper installation and
servicing may be rendered difcult.
To Next Page
Loading...
Need help?
General
