11
D. Tilt Sensor
If the mower is tilted up towards a vertical position, the
blade will stop immediately.
E. Obstruction Sensor
Your mower detects interfering obstacles in its way during
operation. When the mower collides with an obstacle, it
will stop the rotation of the blade immediately, will stop
movement in that direction and reverse itself away from
the obstacle.
F. Emergency Stop Button
Pressing STOP at any time during operation will stop the
mower and the blade immediately.
G. Safety Switch
Switching off the Safety Switch will prevent any operation
of the mower. It is required to switch it off before lifting the
mower and before any maintenance is done.
H. Base Station / Perimeter Switch and
Perimeter Wire
The mower cannot operate without a Perimeter Wire
installed and activated through the Base Station /
Perimeter Switch. In the event the Perimeter Wire signal
is turned off, the mower will stop operating.
C. Lift Sensor
If the mower is raised from the ground during
the blade’s operation, the blade will stop rotating
immediately.
To Next Page
Loading...
