131
Chapter 7 Environment Configuration and
Chapter7
Restoring the Factory Settings
(FACTORY RESET)
This operation can restore all settings of the MC-307 to those
factory default settings.
Caution: If any valuable data reside in the MC-307 main
memory, save the data into an external MIDI sequencer or
other external devices by performing bulk dumps (P. 130)
before executing factory reset.
Operating procedure
1. Press the [SYSTEM] button.
The menu screen for system set-up appears.
2. Press the [F2 (UTIL)] button.
3. Press the [CURSOR (down)] button.
The screen containing the “5 FACTORY RESET” screen
appears.
4. Press [F1 (FACT)] button.
The “FACTORY RESET” screen appears and the “ARE
YOU SURE?” message is displayed.
5. Press [F4 (EXEC)] button to execute factory reset.
It takes about 6 minutes to complete and the
“COPMPLETED!” message appears.
After a while, pattern play screen appears.
Writing Patches and Patterns
in the Memory (WRITE)
This operation writes editing and recording results in the
main memory. This enables patches and patterns to be stored
in the system even after power off.
* It is not possible to enter this setting display while a pattern or
song is playing back. Refer to the following pages for saving
procedures used for the respective items.
- Patch
refer to Saving a Patch (p. 104).
- Rhythm set
refer to Saving a Rhythm Set (p. 113).
- Pattern
refer to Saving the Pattern (p. 83).
- Song
refer to Saving the Song (p. 87).
- Arpeggiator
refer to Saving Arpeggio Settings (Arpeggio Write) (p.
34).
- Pattern Set
refer to Saving a Pattern Set (p. 38).
- RPS Set
refer to Saving the Settings of an RPS Set (p. 41).
Canceling Execution of
Editing and Recording
(Undo/Redo)
It is possible to cancel the results of an editing (pattern/song
edit and microscope edit) or recording operation for a song
or pattern. This is called “Undo.”
It is also possible to cancel the results of the Undo. This is
called “Redo.”
* It is not possible to access this setting page while a pattern or
song is playing back.
Procedure
1. Press the [SYSTEM] button.
2. Press the [F4 (UNDO)] button.
The item subject to UNDO is displayed. For example,
“UNDO MICROSCOPE” appears for undoing
microscopic editing.
3. Press [F4 (EXEC)] button to execute this function, or
press [EXIT] button to cancel.
Upon completion, the “COMPLETED!” message appears
on the display and the screen returns to the selection
screen for system settings.
* UNDO can be executed for Pattern/Song editing, recording
and microscopic editing.
To Next Page
Loading...
Need help?
General
