192
Transmit/Receive Setting List
Parameter EDIT TX/RX Value
MODE1 (Default) MODE2
PITCH COARSE TUNE EXCLUSIVE CC#21 16 - 112 Center=64) *1
FINE TUNE CC#77 CC#77 14 - 114 (Center=64) *1
FILTER FILTER TYPE EXCLUSIVE CC#34 0 - 4 *1
CUTOFF CC#74 CC#74 0 - 127 *1
RESONANCE CC#71 CC#71 0 - 127 *1
AMPLIFIER TONE LEVEL EXCLUSIVE CC#36 0 - 127 *1
TONE PAN EXCLUSIVE CC#35 0 - 127 (Center=64) *1
RND PAN EXCLUSIVE CC#37 0 (OFF), 63 (ON) *1
P-ENVELOPE DEPTH EXCLUSIVE CC#25 52 - 76 (Center=64) *1
A EXCLUSIVE CC#26 0 - 127 *1
D EXCLUSIVE CC#27 0 - 127 *1
S EXCLUSIVE CC#39 0 - 127 (Center=64) *1
R EXCLUSIVE CC#40 0 - 127 *1
F-ENVELOPE DEPTH CC#81 CC#81 1 - 127 (Center=64) *1
A CC#82 CC#82 0 - 127 *1
D CC#83 CC#83 0 - 127 *1
S EXCLUSIVE CC#28 0 - 127 *1
R EXCLUSIVE CC#29 0 - 127 *1
A-ENVELOPE A CC#73 CC#73 0 - 127 *1
D CC#75 CC#75 0 - 127 *1
S EXCLUSIVE CC#31 0 - 127 *1
R CC#72 CC#72 0 - 127 *1
LFO1 WAVEFORM EXCLUSIVE CC#15 0 - 7 *1
RATE CC#16 CC#16 0 - 127 *1
P-DEPTH CC#18 CC#18 1 - 127 (Center=64) *1
F-DEPTH CC#19 CC#19 1 - 127 (Center=64) *1
A-DEPTH CC#80 CC#80 1 - 127 (Center=64) *1
PORTAMENTO SW CC#65 CC#65 0 - 63 (OFF), 64 - 127 (ON)
TIME CC#5 CC#5 0 - 127
SOLO CC#126/127 CC#126/127 126=1 (ON), 127=0 (OFF)
PART MIXER LEVEL CC#7 CC#7 0 - 127
PAN CC#10 CC#10 0 - 127 (Center=64)
KEY SHIFT EXCLUSIVE CC#85 16 - 112 (Center=64)
REVERB CC#91 CC#91 0 - 127
DELAY CC#94 CC#94 0 - 127
M-FX SW EXCLUSIVE CC#86 0 (OFF), 1(ON), 4(M-FX)
* If these controls are moved during playback of a Pattern, the data stored in the sequencer stops being sent to the sound module (this is
because operation of these controls takes precedence over the playing of sounds). The system remains in this status until another Pattern is
called up.
To Next Page
Loading...
Need help?
General
