80
Chapter 5 Creating Your Own Patterns and
Modifying the Strength of Notes
(Change Velocity)
This operation modifies the velocity (strength) of the notes
recorded in the pattern. Increasing the velocity values will cause
the notes to be played more strongly. This operation can be used
to increase or decrease the note dynamics.
Procedure
Selects a pattern for which Change Velocity is to be executed.
1. Press the [PTN] button.
2. Using the [VALUE] dial or the [INC/DEC] buttons,
select the pattern on which Change Velocity is to be
executed.
Invoke the screen for executing Change Velocity.
3. Press the [F3 (EDIT)] button.
4. Press the [F2 (TRACK EDIT)] button.
The screen for selecting Pattern Edit appears.
5. Press the [CURSOR (left)] button to invoke the screen
displaying “VELOCITY.”
6. Press the [F2 (VELO)] button.
The screen for editing Change Velocity appears.
7. Select the part to be edited using the relevant PART
button, [R], [1] to [7].
8. Press the [CURSOR (up)] button to move the cursor to
“VALUE.”
9. Using the [VALUE] dial or the [INC/DEC] buttons,
specify the amount by which velocity is to be changed.
10.Press the [CURSOR (up)] button to move the cursor to
“NOTE RANGE.”
11.Using the [VALUE] dial or the [INC/DEC] buttons,
specify the range of the note messages to be changed
velocity.
* You can also specify this by pressing a keyboard pad.
Now, execute change velocity.
12.Press the [F4 (OK)] button.
A screen asking you whether or not you want to execute
Transpose appears.
13.Press the [F4 (EXEC)] button.
Change Velocity is executed and, upon completion, the
normal display reappears.
Range:
VALUE: -99–0– +99
NOTE RANGE: C -1–G 9
* If this operation would result in a velocity greater than 127 (or
less than 1), the result will be limited to 127 (or 1).
* If you wish to change velocity only a specific range of notes,
press the keyboard pad to specify the desired range. If you do
not specify the note range, all notes will be transposed.
Modifying the Note Length
(Change Gate Time)
This operation modifies the gate time (duration) of the notes
recorded in the pattern. This can be used to make the overall
performance more staccato or tenuto.
Procedure
Select the pattern for which Change Gate Time is to be
executed.
1. Press the [PTN] button.
2. Using the [VALUE] dial or the [INC/DEC] buttons,
select the pattern for which Change Gate Time is to be
executed.
Invoke the screen for executing Change Gate Time.
3. Press the [F3 (EDIT)] button.
4. Press the [F2 (TRACK EDIT)] button.
The screen for selecting Pattern Edit appears.
5. Press the [CURSOR (left)] button to invoke the screen
displaying “GATETIME.”
6. Press the [F3 (GATE)] button.
The screen for editing Change Gate Time appears.
7. Select the part to be edited using the relevant PART
button, [R], [1] to [7].
8. Press the [CURSOR (up)] button to move the cursor to
“VALUE.”
9. Using the [VALUE] dial or the [INC/DEC] buttons,
specify the amount by which gate time is to be changed.
10.Press the [CURSOR (down)] button to move the cursor to
“NOTE RANGE.”
11.Using the [VALUE] dial or the [INC/DEC] buttons,
specify the range of the note messages to be changed
Gate Time.
* You can also specify this by pressing a keyboard pad.
Now, execute Change Gate Time.
To Next Page
Loading...
Need help?
General
