Roland RD-700NX User Manual

35
Performance
Adjusting the Levels of Each Frequency Range (EQUALIZER)
The RD-700NX is equipped with a four-band equalizer.
You can use the EQUALIZER [LOW] knob, [LOW MID] knob, [HIGH MID] knob, and [HIGH] knob to adjust the level of each frequency range.
By holding down the [EXIT/SHIFT] button and turning the corresponding knob, you can adjust the center frequency of each frequency range.
NOTE
Equalization is applied to the overall sound output from the OUTPUT jacks.
1 32
1. Press the EQUALIZER [ON/OFF] button to make its indicator light.
A screen like the one shown below appears, and the equalizer is turned on.
2. Turn the knobs to adjust the levels and the frequency in each range.
Rotating a EQUALIZER knob ([LOW] knob, [LOW MID]
knob, [HIGH MID] knob, [HIGH] knob) in the negative
direction cuts the level of that frequency range;
rotate it in the positive direction boost the level of
that range.
In addition, holding down the [EXIT/SHIFT] button
and turning a knob toward the negative direction
will lower the frequency, and turning it toward the
positive direction will raise the frequency.
You can press the [TONE EDIT] (NUMERIC)button to get a numerical reading for the value of the setting. Pressing the [TONE EDIT] (NUMERIC) button
toggles you between “NUMERIC” and “GRAPHIC” as the format for what you see indicated in the screen.
The way settings are made di ers depending on the format used, as follows:
When the Graphic format is used
• Slightly adjust the knob for the range in which you want to change the value to move the cursor.
• Press the Cursor [
] [ ] buttons to adjust the frequency.
• Press the Cursor [
] [ ] buttons to adjust the Q.
When the Numeric format is used
• Press the Cursor [ ] [ ] [ ] [ ] buttons to move the cursor.
• Press the [DEC] [INC] buttons to change the value.
• Repeatedly press the [Layer EDIT] (BAND) button to step through the frequency ranges for editing.
• In the low range (LOW) and high range (HIGH) screens, you can switch the equalizer type.
Parameter Value
Type Shelving, Peaking
3. To turn the equalizer o , press the EQUALIZER [ON/OFF] button, extinguishing its indicator.
MEMO
You can set the RD-700NX so that the equalizer settings are not changed when you change Live Sets (p.
44). Refer to“Preventing Equalizer Settings from Being Switched (EQ Mode)” ( p. 67).
NOTE
Sounds may be distorted with certain knob settings. If this occurs, adjust the Input Gain on the upper of the “NUMERIC” screen.
GRAPHIC NUMERIC

Roland RD-700NX Specifications

Power

power consumption	12 W

Audio and Sound

maximum polyphony	128 voices
sound generator	SuperNATURAL Piano, SuperNATURAL (E.Piano), Virtual Tone Wheel Organ, PCM Sound Generator, GM2 (for SMF Playback)
effects	Multi-Effects (2 x 4 systems, 84 types), Reverb (6 types), Chorus (3 types), 3-band Compressor, 4-band Digital Equalizer

Connectivity

output jacks	L/MONO, R Jacks (1/4-inch phone type), BALANCED OUT (L, R) Jacks (XLR type)
pedal jacks	DAMPER Pedal Jack, Control Pedal Jacks (FC1, FC2)
midi connectors	IN, OUT1, OUT2, THRU/OUT3

Weight and Dimensions

width	1, 444 mm (56-7/8 inches)
depth	375 mm (14-13/16 inches)
height	148 mm (5-7/8 inches)
weight	25.0 kg (55 lbs 2 oz)