3 x Installation
21
FA ROTEX Solaris - 08/2007
3.3.3 Installing the common return flow pipe
1. Mount the RPS3 but do not fit the silencer hood (see Chapter 3.2).
2. Remove the sealing cap from the solar return flow coupling of the 2nd storage tank.
3. Align the Sanicube storage tank. The centre-to-centre distance between the storage tanks must be 830 mm. Also observe
the necessary clearance of 200 mm to any wall.
4. Prepare the storage tank connection angle to the RPS. To do that, on the extension side, remove the shackle and depending
on the installation until now, remove the ball valve or the blind plug (see page 13 steps 4 and 5).
5. Fit the removed part to the return flow connection pipe premounted by ROTEX on the 2nd storage tank connection.
6. Insert the thus completed return flow pipe on the side with the free push-in fitting (Ø28) on the free jump of the storage
tank connection.
WARNING!
Danger of scalding after disconnecting the CONSX from the storage container or during work on the pipework
of the control and pump unit (e.g. when replacing a pump).
• Drain the storage container before starting work on the equalisation pipe or other pipework.
CAUTION!
Large amounts of water can escape from the Sanicube during installation.
• Install the Solaris storage tank extension set before filling the Sanicubes (non-pressurised area).
6 Solaris feed distributor
9 Connection T-piece
CON SX A Storage extension set (below)
CON SX B Storage extension set (top)
FLS Flow sensor
FLG FlowGuard
Fig. 3-46 Installing the common return flow pipe
To Next Page
Loading...
Need help?
General
