Hardware Installation and Reference Guide Preparing for Installation
17
Caution
Any nonstandard and inaccurate electrical operation can cause accidents such as fires or electrical attacks,
thus causing severe, or even fatal damages to human bodies and the devices.
Direct or indirect touch through a wet object on high-voltage and mains supply can bring a fatal danger.
2.1.4 Electrostatic Discharge Safety
When the static electricity exceeds a certain value, it will damage the circuit and device. The electrostatic
induction mainly comes from outdoor high voltage power lines, lightning and other external electric fields, indoor
floor materials and the internal structure of the device.
To prevent damage from static electricity, please pay attention to the following tips:
Properly ground the device and floor.
Keep the indoor installation environment clean and free of dust.
Maintain appropriate humidity conditions.
Before installing the various pluggable modules, please wear an anti-static wrist strap and make sure that it
is well grounded.
Do not touch the components and printed circuit board of the module directly with your hands.
Use an ESD bag to keep the module.
Avoid clothing and other items in contact with the circuit board. The anti-static wrist strap can only prevent
damage to the circuit board caused by static electricity on the body. Static electricity on clothing cannot be
prevented.
2.1.5 Laser Safety
Among the modules supported by the RG-S6150-X series switches, there are many transceiver modules that
are Class I laser product.
Precautions:
When a fiber transceiver works, ensure that the port has been connected with a fiber or has been covered
by a dust cap so as to keep out dust and prevent it from burning your eyes.
Do not stare at any fiber port.
Caution
Do not stare at any fiber port under any circumstances, as this may cause permanent damage to your eyes.
2.2 Installation Environment Requirements
Install the RG-S6150-X series switches indoors. To ensure the normal operation and prolonged service life of
the device, the installation site must meet the following requirements.
2.2.1 Cabinet Installation Requirements
If the switch is installed inside a cabinet, the following conditions must be met:
To Next Page
Loading...
Need help?
General