Hardware Installation and Reference Guide Installing the Switch
24
The power supply and required current are available at the installation site.
The Ethernet cables have already been deployed at the installation site.
3.3 Mounting the Cabinet
Precautions
When mounting the cabinet, please note the followings:
All expansion bolts for fastening the cabinet base to the ground should be installed and tightened in sequence
from bottom to up (large flat washer, spring washer, and nut), and the installation holes on the base and the
expansion bolts are properly aligned.
The installed cabinet should not be moved.
The installed cabinet should be vertical to the ground.
When multiple cabinets are placed side by side in the equipment room, they should be aligned with each
other, leaving an error less than 5 mm (0.20 in.).
The front/rear doors of the cabinet should be installed to allow you open and close them smoothly. The locks
should work normally, and all keys should be complete.
There should be no unnecessary and informal labels inside the cabinet and on service modules.
Filler panels are installed in the empty slots.
The screws in the cabinet should be fasten tightly and be of the same model.
The device is securely installed, and the screws on the panel should be fastened tightly.
All wiring outlets at the top and bottom of the cabinet should be installed with rodent-resistant nets with
clearance of no more than 15 mm (0.59 in.) in diameter to prevent rodents and other small animals from
entering the cabinet.
Antistatic wrist straps should be provided in the cabinet.
Installation Steps
(1) Plan the available space before installing the cabinet. Reserve enough space for the front and rear doors for
device maintenance.
(2) Install and fasten the cabinet in the designed position as planned.
(3) Install the appropriate cable troughs and cables.
(4) Install the tray and cable management brackets on the rack according to the number of devices installed into
the cabinet.
3.4 Mounting the Switch
Precautions
Before installing the RG-S6150-X switch in a cabinet, please check whether the racks are properly positioned. If
the racks are too close to the front door of the cabinet, you may not be able to close the front door after plugging
To Next Page
Loading...
Need help?
General