MODEL：F67Q/F71Q/F68Q/F69Q/F116Q/F117Q
30
Function:
When valve is in service status, if water tank is short of water, pump starts
working. If water tank has enough water, the switch of liquid level controller
is closed, so pump does not work.
When valve is in regeneration cycle, no matter what water condition is in
water tank, open the pump to make sure there is water on inlet. As Runxin
valve no water passes outlet in regeneration cycle, it ensures no water fill into
brine tank.
A liquid switch at the top opening well or in middle water tank in RO
system protects pump from working without water in case of out of raw water.
3） Liquid Level Switch in Water Tank Controls Inlet pump (Three-phase
motor, Figure 3-6) (Set as b-01)
To Next Page
Loading...
Need help?
General
