2-4 Crawl Operation Panel
8B
~c
A.
~
Emergency stop button
When
pushing this button, the press will stop and
the
button
will
lock. In this condition, the press
cannot
be
run
and
also crawl operation cannot be
done.
When
turning the button in the direction
of
the arrow, the lock will be released and the press can
be run and crawled.
B.
IT§]
Reverse crawl button
WARNING
Never touch the rotating parts when doing the
crawl
operation.
Failure
to
follow
this
instruction may result
in
a serious injury.
When
pushing this button with the crawl ON/OFF
button
on
this panel locked, the press will crawl in
the reverse direction.
There are 2 different kinds
of
crawl operation speed
(1
m/min. and 3 m/min.).
( ..,. Safety Operation Edition - 19)
C.
~Crawl
ON/OFF button
When
pushing this button, the press will stop and
the
button
will
lock.
In
this condition, the press
cannot
be
run, but the crawl operation can be done.
When turning the button in the direction
of
the arrow,
the lock will be released and the press can be run.
D.
[§]
Forward crawl button
WARNING
Never touch the rotating parts when doing the
crawl
operation.
Failure
to
follow
this
instruction may result in a serious injury.
When
pushing this button with the crawl ON/OFF
button
on
this panel locked, the press will crawl in
the forward direction.
There are 2 different kinds
of
crawl operation speed
(1
m/min. and 3 m/min.).
(..,. Safety Operation
Edition-
19)
Chapter 2 Names and Functions
A WARNING
..
Never touch the rotating parts when doing the
crawl operation. Failure
to
follow this instruction
may result in a serious injury.
• The crawl ON/OFF buttons and
crawl
buttons are
located at the 2 places marked 1 and 2.
The crawl operation is possible when the crawl ON/
OFF button on each panel is pushed. When pushing
the crawl ON/OFF button, the lamp will light.
a.
While lighted ....... The crawl operation can be done.
b. While flickering
..
The
crawl operation cannot
be
done.
(
2 crawl ON/OFF buttons are )
pushed
or
a safety
device
is
actuated.
c. While OFF .......... The crawl operation cannot be
done.
• Plate cylinder predetermined position stop
function
With
the
drive
lamp
lighted,
when
pushing
the
(forward/reverse) crawl button 1
or
2 shown in the
illustration, the press crawls and stops automatically
at the position where mounting/removing the plate can
be done easily.
Crawl button
Plate cylinder stop position
[§]
Position where it is easy to mount a
1
plate on the first unit
IT§]
Position where it is easy to remove a
plate on the first unit
[§]
Position where it is easy to mount a
plate on the second unit
2
Position where it is easy
to
remove a
IT§]
plate on the second unit
Introduction Edition - 19
To Next Page
Loading...
Need help?
General
