Chapter
3 Printing Practice
3-2
Thin
Paper
Feeding
[Paper
with
a
thickness
less
than
0.08
mm
(0.0031 ")] (Point)
A CAUTION
Stop the press before setting. Failure to follow this instruction
may
result in
an
injury.
1) Adjust the
paper
pile height.
Pile height
scale
---t~---1
Sheet
separator
bracket
Adjust the paper pile height for the thin paper.
2) Set the suction feet
and
control the vacuum.
Please do not use the rubber suckers on the suction feet.
Set the vacuum to be as weak as possible.
(Note)
If
the rubber suckers
or
strong vacuum is used, the paper will
be
squeezed by the suction feet and will not be fed straight up to the
pull-out rollers.
3) Control the center blower
and
side blower.
Sheet separator
Operation Edition - 70
Control the center blower and side blower volume so that the top 5 to 6
sheets
of
paper are separated and so that the top sheet lightly contacts the
sheet separator.
To Next Page
Loading...
Need help?
General
