24
Press the ON/STAND-BY button on the side control
or on the remote control, and “Power off?” appears
on the screen.
Press the ON/STAND-BY button on the side control
or on the remote control again to turn off the
projector. The LAMP indicator lights bright and the
READY indicator turns off. After the projector is
turned off, the cooling fans operate for 90 seconds.
You cannot turn on the projector during this cooling
down period.
1
2
TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU
TURN THE PROJECTOR ON, WAIT AT LEAST FIVE
MINUTES BEFORE TURNING IT OFF.
DO NOT UNPLUG THE AC POWER CORD WHILE
COOLING FANS ARE RUNNING OR BEFORE THE
READY INDICATOR LIGHTS GREEN AGAIN.
OTHERWISE IT WILL RESULT IN SHORTENING OF
THE LAMP LIFE.
3
When the projector has cooled down enough, the
READY indicator lights green and then you can turn
on the projector. To unplug the AC power cord, wait
until the projector is completely cooled down.
“Power off?” disappears after 4 seconds.
✔Note:
• When the On start function is set to “On,” the projector will be
turned on automatically by connecting the AC power cord to an
AC outlet (p.51).
• The running speed of cooling fans is changed according to the
temperature inside the projector.
• Do not put the projector in a case before the projector is cooled
enough.
• If the WARNING TEMP. indicator blinks red, see “Warning
Indicators” on page 69.
• The projector cannot be turned on during the cooling period
with the READY indicator turned off. You can turn it on again
after the READY indicator becomes green again.
Turning Off the Projector
DO NOT OPERATE THE PROJECTOR CONTINUOUSLY
WITHOUT REST. CONTINUOUS USE MAY RESULT
IN SHORTENING THE LAMP LIFE. TURN OFF THE
PROJECTOR AND LET STAND FOR ABOUT AN HOUR
IN EVERY 24 HOURS.
Basic Operation
Downloaded From projector-manual.com Sanyo Manuals
To Next Page
Loading...
Need help?
General
Weight and Dimensions
