Sanyo PLC-XF47 User Manual

68
Indicators and Projector Condition
Check the indicators for the projector condition.
Indicators
Projector Condition
LAMP
red
READY
green
WARNING
TEMP.
red
LAMP
REPLACE
orange
The projector is off. (The main switch is OFF position or the AC power
cord is unplugged.)
The projector is in stand-by mode. Press the ON/STAND-BY button to
turn on the projector.
The projector is operating normally.
The projector is preparing for stand-by or the projection lamp is
being cooled down. The projector cannot be turned on until cooling is
completed and the READY indicator lights green.
The projector is in the Power management mode.
The projector is operating normally.
• • • on
• • • off
• • • blinking at the normal rate
(approx. 1 second ON,
1 second OFF)
• • • dim
• • • blinking slow
(approx. 2 seconds ON,
2 seconds OFF)
• • • blinking fast
(approx. 0.5 seconds ON,
0.5 seconds OFF)
✽
✽
✽
✽
Appendix
✽
When the projection lamp reaches its end of life, the LAMP REPLACE indicator lights orange.
When this lights orange, replace the projection lamp a new one promptly. Reset the lamp
counter after replacing the lamp (p.57)
Downloaded From projector-manual.com Sanyo Manuals

Sanyo PLC-XF47 Specifications

General

Vertical scan range	48 - 120 Hz
Horizontal scan range	15 - 120 kHz
Projection technology	LCD
Contrast ratio (typical)	2000:1
Screen size compatibility	40 - 600 \
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	80 °
Keystone correction, horizontal	40 °
I/O ports	Analog (D-sub15), Serial in & Serial out (D-Sub 9 x 2)
Video out	UXGA, SXGA+, SXGA, WXGA, XGA, SVGA, VGA, MAC
Resolution	2359296 pixels
Aspect ratio	4:3
RS-232 ports	1
Dimensions (WxDxH)	581 x 815.5 x 251.5 mm
Power requirements	200-240 V AC 9.7 A Max, 50 / 60 Hz
Connectivity technology	Wired
Lamp type	NSH
Lamp power	330 W
Light source type	Lamp
Dot clock scanning frequency	230 MHz
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (typical)	1700 W

Weight and Dimensions

Weight	36500 g