Sanyo PLC-XF47 User Manual

7
Use the projector properly in specified positions.
Improper positioning may reduce the lamp life and
result in severe accident or fire hazard.
Installing the Projector
in Proper Directions
Avoid positioning the projector as described below
when installing.
Positioning Precautions
Do not roll the projector more
than 10 degrees from side to
side.
For ceiling mounting, you need the ceiling
mount kit designed for this projector. When
not mounted properly, the projector may fall,
causing hazards or injury. For details, consult
your dealer. The warranty on this projector
does not cover any damage caused by use
of any non-recommended ceiling mount kit
or installation of the ceiling mount kit in an
improper location.
CAUTION ON CEILING MOUNTING
Safety Instructions
NO UPWARD
Do not point the projector up
to project an image.
10˚
10˚
NO DOWNWARD
NO SIDEWAYS
Do not point the projector
down to project an image.
Do not put the projector
on either side to project an
image.
IMPORTANT!
Filter Maintenance!!
The projector uses a lamp which generates significant
heat. The cooling fans and air vents are provided to
dissipate the heat by drawing air into the housing and
the filter is located in the intake vents to prevent dust
from getting inside of the projector.
In order to care for the projector appropriately, regular
cleaning is required. Remove any dirt or dust that has
accumulated on the projector or in the filter.
If the projector reaches a time set in the timer setting,
a Filter warning icon (Fig. 1) appears on the screen.
Blocking the air vents and leaving the projector
uncleaned for a long time may not only damage the
projector and may require costly repairs but may also
cause accidents or fire.
For maintenance of the filter, refer to “Filter counter”
on page 54 and “Maintenance and Care” on pages 55.
Damages to the projector caused by using an
uncleaned filter or improper maintenance will void
the warranty on the projector.
Fig.1 Filter warning icon
10˚
10˚
Do not pitch the projector
more than 10 degrees
backward and forward.
Downloaded From projector-manual.com Sanyo Manuals

Sanyo PLC-XF47 Specifications

General

Vertical scan range	48 - 120 Hz
Horizontal scan range	15 - 120 kHz
Projection technology	LCD
Contrast ratio (typical)	2000:1
Screen size compatibility	40 - 600 \
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	80 °
Keystone correction, horizontal	40 °
I/O ports	Analog (D-sub15), Serial in & Serial out (D-Sub 9 x 2)
Video out	UXGA, SXGA+, SXGA, WXGA, XGA, SVGA, VGA, MAC
Resolution	2359296 pixels
Aspect ratio	4:3
RS-232 ports	1
Dimensions (WxDxH)	581 x 815.5 x 251.5 mm
Power requirements	200-240 V AC 9.7 A Max, 50 / 60 Hz
Connectivity technology	Wired
Lamp type	NSH
Lamp power	330 W
Light source type	Lamp
Dot clock scanning frequency	230 MHz
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (typical)	1700 W

Weight and Dimensions

Weight	36500 g