Sanyo PLC-XF47 User Manual

69
Indicators
Projector Condition
LAMP
red
READY
green
WARNING
TEMP.
red
LAMP
REPLACE
orange
The temperature inside the projector is elevated close to the
abnormally high level.
The temperature inside the projector is abnormally high. The projector
cannot be turned on. When the projector is cooled down enough and
the temperature returns to normal, the READY indicator lights green
and the projector can be turned on. (The WARNING TEMP. indicator
keeps blinking.) Check and clean the filter.
The projector has been cooled down enough and the temperature
returns to normal. When turning on the projector, the WARNING TEMP.
indicator stops blinking. Check and clean the filter.
Any of 4 lamps becomes out, Lamp Mode is changed over from 4 lamps to 2
lamps. And when any of 2 lamps are out, a projector operates with 1 lamp.
The lamp has been used overtime. Replace the lamp immediately
and then reset the lamp counter. The indicator will be turned off after
resetting the counter.
The projector detects an abnormal condition and cannot be turned on.
Unplug the AC power cord and plug it again to turn on the projector. If
the projector is turned off again, unplug the AC power cord and contact
the dealer or the service center. Do not leave the projector on. It may
cause an electric shock or a fire hazard.
✽
Appendix
The projector is detecting abnormal condition.
✽
✽
✽
✽
✽✽✽
Downloaded From projector-manual.com Sanyo Manuals

Sanyo PLC-XF47 Specifications

General

Vertical scan range	48 - 120 Hz
Horizontal scan range	15 - 120 kHz
Projection technology	LCD
Contrast ratio (typical)	2000:1
Screen size compatibility	40 - 600 \
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	80 °
Keystone correction, horizontal	40 °
I/O ports	Analog (D-sub15), Serial in & Serial out (D-Sub 9 x 2)
Video out	UXGA, SXGA+, SXGA, WXGA, XGA, SVGA, VGA, MAC
Resolution	2359296 pixels
Aspect ratio	4:3
RS-232 ports	1
Dimensions (WxDxH)	581 x 815.5 x 251.5 mm
Power requirements	200-240 V AC 9.7 A Max, 50 / 60 Hz
Connectivity technology	Wired
Lamp type	NSH
Lamp power	330 W
Light source type	Lamp
Dot clock scanning frequency	230 MHz
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (typical)	1700 W

Weight and Dimensions

Weight	36500 g