EasyManuals Logo
Home>Sanyo>Projector>PLC-XL51A

Sanyo PLC-XL51A Service Manual

Sanyo PLC-XL51A
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
- 14 -
Security Function Notice and Standby mode Notice
This projector provides security functions such as "Key lock", "PIN code lock" and "Logo PIN code lock". When the projector has
set these security function on, you are required to enter correct PIN code to use the projector. If you do not know the correct
PIN code to the projector, the projector can no longer be operated or started. In this case, you must reset those function first
according to the resetting procedure described below and then check up on the projector.
Function Description
Key lock
Locks operation of the top control or the remote control.
If the Key lock is enabled with top control lock, the projec-
tor can no longer be started.
Initial setting: Key lock function is disabled
PIN code lock
Prevents the projector from being operated by an unau-
thorized person.
Initial code: “1234
Logo PIN code lock
Prevents an unauthorized person for changing the start-
up logo and captured image on the screen.
Initial code: “4321
Security Function Disable
Resetting procedure
1. Disconnect the AC power cord from the AC outlet.
2. As pressing the SELECT button connect the AC power cord into an AC outlet again.
3. Keep pressing the SELECT button and then press the ON/STAND-BY button.
4. Release the ON/STAND-BY button first and then release the SELECT button.
The PIN code lock and Logo PIN code lock will be reset as the initial PIN code at the factory and the Key lock function is
disabled.
Please refer to the owner's manual for further information of the security functions.
Standby mode Notice
This function is used to change the setting of standby electricity.
Eco ..........................Standby electricity becomes small.
The projectors network function will stop when controlling the projector with RS-232C.
Network ............Standby electricity becomes large.
Note:
When “Eco is selected, several functions will be restricted.
Function Eco mode
Serial Command control
X
(Only possible Power ON ----
)
Network Function X
Monitor Out X
Audio Out X
On start
Restricted Function at the Eco mode

Table of Contents

Other manuals for Sanyo PLC-XL51A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLC-XL51A and is the answer not in the manual?

Sanyo PLC-XL51A Specifications

General IconGeneral
BrandSanyo
ModelPLC-XL51A
CategoryProjector
LanguageEnglish

Related product manuals