31 English
Turning on the camera when the power save
(sleep) mode is active
In order to preserve battery pack power, the power save (sleep) function will
automatically turn off the camera after about 1 minute of no use during
shooting, or about 5 minutes of no use during playback (factory-preset
setting).
i When the power save mode is active, you can restore the power by any of
the following methods:
h Press the ON/OFF button.
h Press the [ ] button.
h Open the monitor unit.
i After the power save mode has been active for about 30 minutes, the
camera will switch to the standby mode. In this case, you can restore the
power by pressing the ON/OFF button, or by closing and then opening the
monitor unit.
i When the AC adaptor (optional) is connected, the power save mode will
become active about 5 minutes after the camera is turned on (factory-
preset setting).
i The user can specify the time elapsed before the power save mode is
activated (page 127).
i When the camera is connected to a computer or printer, the power save
mode becomes active after about 12 hours.
To Next Page
Loading...
Need help?
General
