Segway x2 SE Service Manual

Segway Personal Transporter SE Service Manual
4–3
x2 SE Wheel Assembly
Removal
Tool Required: 13 mm socket wrench
1. Make sure the PT is powered off and unplugged.
2. Support the PT or turn it on its side.
3. Using a 13 mm socket wrench, remove the three
wheel nuts and discard. See Figure 4–2.
4. Remove the x2 SE Wheel Assembly.
Installation
Tools Required: Isopropyl alcohol wipes
13 mm socket wrench
Torque wrench
1. Make sure the PT is powered off and unplugged.
2. Support the PT or turn it on its side.
3. Inspect the mounting surfaces; use isopropyl
alcohol wipes to clean off all debris.
4. Place the x2 SE Wheel Assembly on the gearbox
flange. See Figure 4–2.
5. Holding the wheel to prevent rotation, use a 13 mm
socket wrench to install the three wheel nuts. Torque
to 30 N-m (22 ft-lbf).
6. Perform post-service tests (page A–1).
Tire/Wheel Assembly
Figure 4–2: x2 SE Tire/Wheel Assembly
x2 Wheel
Gearbox Flange
Wheel Nuts
20158-00001
30 N-m (22 ft-lbf)

Segway x2 SE Specifications

General

Brand	Segway
Model	x2 SE
Category	Scooter
Language	English