LC-24LE170I
6 – 1
CHAPTER 6. ADJUSTMENT
[1] ADJUSTMENT
3.
Software
upgradin
g.
1) Plug o the LCD
TV.
2) Insert the USB device to the USB terminal at the LCD
TV.
(Make sure that the latest software is installed in the USB
device).
3) Hold the LCD TV power key and plug on the LCD
TV.
4) LCD TV is on and detecting the USB
device.
5) A few seconds later, L ED lig h t ( o r a n g e ) w i l l b l i n k i n d i c a t i n g the software
upgrading.
7) TV will automatically restart when software is successfully installed
8) LCD TV is running with the latest software.
[1]
ADJUSTMENT PROCEDURE
1.
Entering
and cancel
the adjustment process mode
1) While holding down the POWER and CENTER keys at the same time, plug in the AC CORD to turn the power
Backlight turned ON, screen display show Black pattern and LED blinking GREEN --> RED --> GREEN --> RED.
2)
Enter password “UP (CH UP) --> DOWN (CH DOWN) --> UP (CH UP)”. (After 30 sec password not keyed in or password keyed in wrong, go to previous
Power Status (On, Standby or OFF).
3)
2.
Remote controller
key operation and description
of display in adjustment process mode.
Remote controller key
Main
unit key
F
unc
tion
CH ( /
)
Changing selecting ine (UP/DOWN)
VOL(+ /
–)
Cursor ( /
)
——————
egapagninruT
(PREVIOUS/NEXT)
Cursor ( /
)
Changing
a selected line setting
(+10/-10)
INPUT button on
remote
controller
CENTER
elggot(gnihctiwsecruostupnI
switching)
(TV INPUT1 INPUT2
)
RETNE
* Input mode is switched aut omatically when relevant adjustment is started so far as the
necessary
input signal is
available.
Backlight turned ON, screen display show Purple test pattern (LED still blinking GREEN --> RED --> GREEN --> RED)
4)
Press the Center Key (The adjustment process mode screen appears).
5)
——————
——————
UP/DOWN
LEFT/RIGHT
Changing selecting line setting (+1/-1)
Enter
To Next Page
Loading...
Need help?
General