12
First Time Installation
FIRST TIME INSTALLATION
Introduction
When the set fi rst turns on, it
enters the First Time Installation
mode. This can be restarted by
restoring the set to default settings
in the ‘ABOUT TV’ menu
Languages
Select your preferred on-screen
display language. This will change
the language in which the menus
and associated information is
displayed. To change this press
the [MENU] button and then
select Settings > System Menu >
Language
Agreement 1
Agree to the Data Collection
and Firmware update notice.
Agreement 2
Agree to the manufacturers’
Terms of Use. (Only applicable to
Freeview Play sets.)
Country Selection
Select the correct fl ag for the
country in which the set will be
used. This will enable the set to
correctly install the functions
applicable to the country of use.
Environment of Use
Home Mode: For normal use,
by default, it is set to a power
saving mode which reduces
the energy used by up to 25%
(by reducing the power to the
LED/LCD panel). This can be
changed in the picture mode
settings.
Network setup
You can connect the TV to
your broadband router or
wireless network in order to
take advantage of the Smart
functions. If you connect the TV
to your router using an Ethernet
cable (recommended) this step
will be skipped.
Select Wi-Fi Network
Select the Wi-Fi network which
you would like to be connected
to. A padlock symbol next to the
network indicates that it will
require a password to use.
Entering Password
Use the arrow buttons on the
remote control to select the
correct character and then press
[OK] to enter. Press the [GREEN]
button to reveal the password.
Initial Document.indd Sec1:12Initial Document.indd Sec1:12 26/11/2018 13:01:2026/11/2018 13:01:20
To Next Page
Loading...
Need help?
General