7
62
Check original cover/SPF open function
When enabled, this function may help prevent wasteful use of toner that occurs
when the original cover/SPF is not completely closed.
If the start ( ) key is pressed when the original cover/SPF is not completely closed,
" " will appear in the display and copying may not take place. If copying does not
take place, copying can be performed by pressing the start ( ) key again, however,
the scan size set in "Copy effective paper width setting function" (program numbers
25, 26, 27) will be used.
If the original cover/SPF is completely closed after " " appears, copying will take
place at the normal size.
TONER SAVE MODE
1
Press the exposure mode selector key
to select the MANUAL ( ) mode.
2
Press and hold down the exposure mode
selector key for approximately 5 seconds.
The MANUAL ( ) indicator will go out
and the PHOTO ( ) indicator will begin
to blink. The light and dark indicator
marked "5" will light up, indicating the
standard toner mode is active.
3
To enter the toner save mode, press the
light ( ) key. The light and dark
indicator marked "1" will light up,
indicating the toner save mode is
selected.
4
Press the exposure mode selector key. The PHOTO ( ) indicator
will stop blinking and light up steadily. The light and dark indicator
marked "3" will light up. The toner save mode is now active.
When this function is off, if the start ( ) key is pressed to make a copy with
the original/SPF cover open, parts outside of the original will be copied black.
Even when this function is on, if the start ( ) key is pressed twice to make a
copy with the original/SPF cover open, parts outside the original may be
copied black. To prevent excessive use of toner, make sure that the original/
SPF cover is closed when making a copy.
To return to the standard mode, repeat the procedure but use the dark
( ) key to select exposure level "5" in step 3.
To Next Page
Loading...
Need help?
General
