CONVENIENT COPY FUNCTIONS
24
Using the document glass
1
Place the original that you wish to copy onto the front side of
the paper on the document glass and close the document
cover/RSPF.
2
Press the [2-SIDED COPY ( )] key until
"1 TO 2" appears, and then press the [OK]
key.
3
3
Press the [ ] key ( ) or [ ] key ( ) to
select the binding edge and then press the
[OK] key.
Select "LONG EDGE" or "SHORT EDGE".
The "LONG EDGE" and "SHORT EDGE" are
shown in the illustration on the preceding page.
4
Select the number of copies and any other settings, and then
press the [START] key ( ).
"[START] : NEXT SCAN [#] : START PRINT" appears and the original is
scanned into memory.
To immediately print the scanned image, press the [ ] key.
5
Replace the original with the next
original and close the RSPF, and
then press the [START] key ( ).
Repeat step 5 until all originals have been
scanned.
Copies will be output each time two originals
have been scanned.
When the number of original pages is odd
and "[START] : NEXT SCAN [#] : START
PRINT" appears, press the [ ] key after all pages have been scanned.
• If you need to clear the data scanned into memory, press the
[CLEAR] key ( ). When the [CLEAR] key ( ) is pressed, the
number of copies setting is also cleared.
• To cancel automatic two-sided copying, press the [CLEAR ALL] key
( ) or press the [2-SIDED COPY ( )] key, select the "1 TO 1",
and then press the [OK] key.
• If the special function sort mode was selected in step 4, copying will
not begin until the [ ] key is pressed.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
