Siemens DP/AS-Interface Link 20E User Manual

Using the Command Interface
78
DP/AS-Interface Link 20E
Release 11/2002
C79000-G8976-C138–04
3.3 Description of the AS-i Slave Commands
Overview
This section describes the command calls that can be sent by the DP master to
the DP/AS-i Link 20E. With these command calls, the DP/AS-i Link 20E provides
the complete functionality of the master profile M1e of the AS-i master
specification. In addition to this, the DP/AS-i Link 20E can be configured
completely by the DP master using command calls.
The use of the jobs is described in the individual descriptions of the jobs
themselves, in the PICS appendix and in the detailed explanations in /1/ and /2/.
The available commands are listed in the table below:
Table 3-6 AS-i Slave Commands
Name
Parameter Return Coding
Set_Permanent_Parameter
–> described in Section 3.3.1
Slave address,
parameter
00
H
Get_Permanent_Parameter
–> described in Section 3.3.2
Slave address Parameter 01
H
Write_Parameter
–> described in Section 3.3.3
Slave address,
parameter
Parameter echo
(optional)
02
H
Read_Parameter
–> described in Section 3.3.4
Slave address Parameter value 03
H
Store_Actual_Parameters
–> described in section 3.3.5
04
H
Set_Extended_Permanent_Configurati
on
–> described in section 3.3.6
Slave address 25
H
Get_Extended_Permanent_Configurati
on
–> described in section 3.3.7
Slave address,
configuration
specified configuration 26
H
Store_Actual_Configuration
–> described in Section 3.3.8
07
H
Get_Extended_Actual_Configuration
–> described in section 3.3.9
Slave address actual configuration 28
H
Set_LPS
–> described in section 3.3.10
LPS 29
H
Set_Offline_Mode
–> described in section 3.3.11
Mode 0A
H
Select_Autoprogramming
–> described in section 3.3.12
Mode 0B
H
Set_operation_mode
–> described in section 3.3.13
Mode 0C
H

Siemens DP/AS-Interface Link 20E Specifications

General

Brand	Siemens
Model	DP/AS-Interface Link 20E
Category	Computer Hardware
Language	English