The power section cables are supplied by the customer at the site and installed between the
transport units, because the filter cabinet does not necessarily need to be sited next to the
converter.
Figure 5-8 Lugs in an additional cabinet (option L09 or Y15)
See also
Output reactor (option L09) (Page 43)
Combining two Transport Units: Output reactor (L09)and Sine-wave filter (Y15) (Page 87)
5.2.12 Connecting the Power Section
Description
With several transport units, the power section cables ② are pulled back into the first transport
unit for transport and must be pulled out of the cable duct ③ on site and connected to the
appropriate lugs ①. The lugs are located on the rear of the converter; each lug and the
associated power section cable have identical markings to prevent wrong connection.
Assembly
5.2 Assembly instructions
SINAMICS PERFECT HARMONY GH180 6SR41 manufactured in NMA Nuernberg, Germany
96 Operating Instructions Rev.201706301306
To Next Page
Loading...
Need help?
General
