52
SMS (Text Messages)
Gigaset SL100/SL150 colour / IM_en / A31008-M1572-R121-2-7619 / sms_neutral_Woody.fm /
28.10.05
Text messages to a PABX
You can only receive a text message when the Calling Line Identification is for-
warded to the extension of the PABX (CLIP).
The CLIP of the number of the SMS centre is evaluated in the Gigaset (telephone).
If your phone is connected to a PABX, you may have to prefix the number of the SMS
centre with an access code (this depends on your PABX). You can store the access code
in your base station (page 85).
If in doubt, you can test your PABX by sending a text message to your own number and
putting the access code before the number of the SMS centre. If you do not receive the
message, send another one, this time without the access code.
When you send messages, your sender number may be sent without your extension
number. The recipient cannot reply to you directly in this case.
Text messages can only be sent and received through ISDN exchanges with the MSN
number assigned to your base station.
Errors when sending and receiving a text message
Errors when sending a text message
The following error codes are displayed:
Errors when receiving a text message
A message appears on the screen if your phone cannot receive any more text messages.
You cannot receive text messages under the following conditions:
◆ The CLIP service (Calling Line Identification Presentation) is not activated for your
phone line,
◆ Call diversion is activated with When: All Calls ,
◆ Call diversion All Calls is activated for the network mailbox,
◆ The memory (incoming and draft message lists) is full.
Error Code Description
E0 Calling Line Identification permanently withheld (CLIR).
Calling Line Identification is not enabled.
FE Error occurred during message transfer.
FD Connection to SMS centre failed.
Text messages cannot be sent or received if the number of an SMS cen-
tre is missing or incorrectly stored. Check that the number of the SMS
centre has been correctly stored.