Siemens LOGO! 8 User Manual

2 Solution
Frei verwendbar House Control with Master-Slave - LOGO! Set 9
Entry ID: 64143308, V2.2, 09/2018
13
© Siemens AG
2018 All rights reserved
2.3.4 Garden watering
Function description
The LOGO! TDE or the LOGO! display can be used to predefine manual or
automatic control of the garden watering.
In manual mode, the garden watering can be controlled with the cursor keys over
the LOGO! controller and the LOGO! TDE.
In automatic mode, the garden watering is switched on for 10 minutes in the
morning at 09:00 a.m. and in the evening at 08:00 p.m. every day.
The function blocks for the automatic control for garden watering can be called up
in parameter assignment mode with the respective block name using the LOGO!
display or LOGO! TDE. If required, parameters like days and times for garden
watering can be adjusted.
Table 2-10
No.
Function
Function block
Block name in the
program
1.
Daily, automatic garden watering
Weekly timer
watering
2.3.5 Interior and exterior lighting
Inputs and outputs
Table 2-11
No.
Hardware
LOGO! module
Program inputs/outputs
1.
Button light on/off room 1
(integrated panic button)
Slave I1
NI1
(network input 1)
2.
Button light on/off room 2
(integrated panic button)
Slave I2
NI2
(network input 2)
3.
Button exterior lighting on/off
(integrated panic button)
Slave I3
NI3
(network input 3)
4.
Central off button
(integrated panic button)
Slave I4
NI4
(Network input 4)
5.
Lighting room 1
Slave Q1
NQ1
(Network output 1)
6.
Lighting room 2
Slave Q2
NQ2
(network output 2)
7.
Exterior lighting
Slave Q3
NQ3
(network output 3)
Note
Signals pending at the inputs of a slave LOGO! should normally be pending for
0.5 seconds so the signals can be transferred safely.

Siemens LOGO! 8 Specifications

General

Brand	Siemens
Model	LOGO! 8
Category	Controller
Language	English