Siemens RUGGEDCOM RX1512 User Manual

Chapter 2
Installing the Device
RUGGEDCOM RX1500
Installation Guide
10 Installing a Power Supply
Section 2.2.1.1
Installing a Power Supply
To install a power supply, do the following:
NOTE
The power supplies are hot swappable. It is not necessary to disconnect power to the device before
installing or removing a power supply.
1. Remove the blank power module assembly or, if equipped, the currently installed power supply. For
information about removing a power supply, refer to Section 2.2.1.2, “Removing a Power Supply”.
2. Insert the power supply into the empty slot. When power is supplied to the device, the top and bottom LEDs
on the power supply should be green, indicating that power is being received and supplied to the device.
3
2
1
Figure 6: Installing a Power Supply
1. Chassis 2. Power Supply 3. Screws
3. Hand-tighten the screws to secure the power supply.
Section 2.2.1.2
Removing a Power Supply
To remove a power supply, do the following:
NOTE
The power supplies are hot swappable. It is not necessary to disconnect power to the device before
Removing or removing a power supply.
1. Remove the screws that secure the power supply.
2. Pull the power supply from the chassis.

Siemens RUGGEDCOM RX1512 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RX1512
Category	Switch
Language	English