Commissioning the device
4.3 Parameter assignment for Comfort Panel
Comfort Panels
Operating Instructions, 07/2017, A5E36770603-AB
103
Changing the printer properties
The HMI device can print on network printers. You can print hardcopies and reports on a
network printer. Line printing of alarms is not possible on a network printer.
The list of current printers and required settings for HMI devices can be found on the Internet
at "Approved printers for SIMATIC HMI Panels
(http://support.automation.siemens.com/WW/view/en/11376409
)".
The Control Panel is open.
1. Open the "Printer Properties" dialog using the "Printer" icon.
Selection list for the printer
Selection list for the interface
Network address of the printer
Drop-down list for printing paper format
"Orientation" group with radio buttons for print orientation
Check box for color quality, valid only for Brother HL 2700 printer
2. Select a printer from the "Printer Language" selection list.
3. Select the port for the printer from the "Port" selection list.
4. If you wish to print via the network, enter the printer's network address in the "Network"
text box.
5. Select a paper format in the "Paper Size" selection list.
6. Activate a radio button in the "Orientation" group.
– "Portrait" for portrait
– "Landscape" for landscape
7. Select the print quality.
– Select the "Draft Mode" check box if you wish to print in draft mode.
– Deactivate the "Draft Mode" check box if you wish to print with higher quality.
To Next Page
Loading...
Need help?
General
