Technical information
8.2 Certificates and approvals
Comfort Panels
Operating Instructions, 07/2017, A5E36770603-AB
187
The following approvals apply to the HMI device in accordance with
● EN 60079-0:2012 +A11 2013
● EN 60079-15:2010
● EN 60079-31:2014
valid:
II 3 G Ex nA IIC Tx Gc
II 3 D Ex tc IIIC T 70 °C Dc IP65
x: Temperature values, see EC design examination certificate
You can find additional information on use of the HMI device in hazardous areas under:
ATEX-FAQ (https://support.industry.siemens.com/cs/ww/en/view/291285
)
The EC type examination certificate is available on the Internet at: Technical Support
(https://support.industry.siemens.com
)
The table below describes the test numbers of the HMI device classes:
Siemens AG
Industry Sector
Werner-von-Siemens-Straße 50
Comfort Panel DEKRA11ATEX0005X
The HMI device fulfills requirements and criteria according to IEC 61131-2, Programmable
Logic Controllers, Part 2: Operating resource requirements and tests.
RCM Declaration of Conformity for Australia/New Zealand
This product meets the requirements of the standards:
● AS/NZS 61000.6.4
● IEC 61000-6-4
This product satisfies the requirement of the Korean Certification (KC Mark).
이 기기는 업무용(A급) 전자파 적합기기로서 판매자 또는 사용자는 이 점을 주의하시기
바라며 가정 외의 지역에서 사용하는 것을 목적으로 합니다.
Note that this device conforms to Limit Class A for emission of radio interference. This
device can be used in all areas except the residential area.
To Next Page
Loading...
Need help?
General
