Operating hardware
4.2 Web server
CP 1604 / CP 1616
Operating Instructions, 02/2017, C70000-G8976-C218-08
51
This box lists detailed information about the selected event.
Select the relevant event in the "Event" information box.
The following steps are required for the configuration:
1. Open the "Object Properties" dialog in the shortcut menu of the relevant CP 1616.
2. Go to the "Web" tab and select the "Enable web server on this module" check box.
3. Select a maximum of two languages to be used to display plain language messages.
4. Save and compile the project and download the configuration to the CP 1616.
Point to note when switching over languages
In the top right corner, you can switch over the language, for example from German to
English. If you change to a language that you have not configured, you will obtain the
information as hexadecimal code instead of plain language.
Module information
Requirement
● You have made the following settings in HW Config:
– enabled the Web server,
– made the language setting,
– generated and enabled "Report system error"
● You have compiled and downloaded the project with STEP 7 HW Config.
● The CP 1616 is in RUN.
To Next Page
Loading...
Need help?
General
