Siemens SIMATIC NET TeleControl S7-1200 CP 1243-1 User Manual

Configuration
4.6 SNMP
CP 1243-1
42 Operating Instructions, 12/2016, C79000-G8976-C365-02
4.6
SNMP
SNMP
The CP supports the following SNMP versions:
●
SNMPv1
Available with security functions disabled.
Note that with this read and write access to the module is possible. In this case, other
settings are not possible.
The configuration of the community strings is only possible if the security functions are
enabled.
The CP uses the following community strings to authenticate access to its SNMP agent
via SNMPv1:
Access to the SNMP agent in the CP
Community string for authentication in SNMPv1
*)
Read access
public
Read and write access private
*) Note the use of lowercase letters!
●
SNMPv3
Available only when security functions are enabled
For information on the configuring SNMPv3, refer to the section SNMP (Page 54).
Configuration
●
"Enable SNMP"
If the option is enabled, communication via SNMPv1 is enabled on the CP.
If the option is disabled, queries from SNMP clients are not replied to by the CP either via
SNMPv1 or via SNMPv3.
4.7
Partner stations
The parameter group is only displayed when telecontrol communication is enabled.
4.7.1
Partner stations > Telecontrol server
Partner stations > "Telecontrol server"
●
Partner number
The partner number for the telecontrol server is assigned automatically by the system if
telecontrol communication is enabled.
●
Station address
The station address of the telecontrol server is assigned automatically by the system if
telecontrol communication is enabled.

Siemens SIMATIC NET TeleControl S7-1200 CP 1243-1 Specifications

General

Brand	Siemens
Model	SIMATIC NET TeleControl S7-1200 CP 1243-1
Category	Controller
Language	English