Siemens SIMOCODE pro Manual

Technical data
10.3 Technical data of the DM-F PROFIsafe fail-safe digital module
98
SIMOCODE pro - Fail-Safe Digital Modules
Manual, 11/2017, NEB631679702000/RS-AA/002
10.3
Technical data of the DM-F PROFIsafe fail-safe digital module
Technical data of the DM-F PROFIsafe fail-safe digital module
Table 10- 3 Technical data of the DM-F PROFIsafe fail-safe digital module
LED
Status
Meaning
READY
Off
System interface not connected/supply voltage too low/device defective
Green
Device ON/system interface OK
Flashing green
Device ON/system interface not active or not OK
DEVICE
Off
Supply voltage too low
Green
Device ON
Red
Device defective or faulty
OUT
Off
Safety-related output not active
Green
Safety-related output active
Flashing green
Feedback circuit not closed although start condition satisfied
SF
Off
No group fault
Red Group fault (PROFIsafe not active, incorrect PROFIsafe address, wiring error,
device defective)
1
Yellow
PROFIsafe address 1
2
Yellow
PROFIsafe address 2
3
Yellow
PROFIsafe address 4
4
Yellow
PROFIsafe address 8
5
Yellow
PROFIsafe address 16
6
Yellow
PROFIsafe address 32
7
Yellow
PROFIsafe address 64
8
Yellow
PROFIsafe address 128
9
Yellow
PROFIsafe address 256
10
Yellow
PROFIsafe address 512
DIP switch
Setting the PROFIsafe address
SET/RESET button
• Indication of the PROFIsafe address
• Resetting of faults (also possible via "TEST/RESET" button on basic unit)

Siemens SIMOCODE pro Specifications

General

Brand	Siemens
Model	SIMOCODE pro
Category	Control Unit
Language	English