Machine data
2.3 Channel-specific machine data
Parameter Manual
122
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
Determination of the chamfer/rounding behavior
Bit 0: (LSB) Assignment of the chamfer/rounding to the preceding or follow-
ing block.
This influences:
• The technology of the chamfer/rounding (feed, type of feed, M commands
...)
• The execution of the blocks without movement in the active plane (e.g. M
commands, movement in the applicate) before or after a modal rounding
(RNDM)
Bit 1: free
Meaning of the individual bits:
Bit 0 = 0
Chamfer/rounding is derived from the following block (default value).
The technology of the chamfer/rounding is determined by the following block.
Blocks without movement (M commands) or movement only in the applicate
between two movement blocks in the plane are executed before the modal round-
ing.
Bit 0 = 1:
Chamfer/rounding is derived from the preceding block.
The technology of the chamfer/rounding is determined by the preceding block.
Blocks without movement (M commands) or movement only in the applicate
between two movement blocks in the plane are executed after the modal round-
ing.
Description: Maximum number of blocks which can appear between the SAR (soft approach and
retraction) block and the traversing block which determines the direction of
the approach or retraction tangent.
20201 CHFRND_MODE_MASK C09 V1
- Chamfer/rounding behavior DWORD Reset
-
- - 0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0 0xFFFF 1/1
20202 WAB_MAXNUM_DUMMY_BLOCKS C02, C06 W1
- maximum number of blocks w/o traversing movement with
SAR
BYTE Reset
-
- - 5, 5, 5, 5, 5, 5, 5, 5... 0 10 7/2
To Next Page
Loading...
Need help?
General
