Siemens SINUMERIK 808D ADVANCED User Manual

Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
313
NC setting data
Description: The setting data defines a typical tool radius. It is only evaluated in com-
pressor COMPCAD. The lower the value, the greater the precision, but the
slower the program execution.
Description: If this setting data is TRUE, block execution is stopped by preprocessing
stop and active tool radius compensation, and does not resume until after a
user acknowledgement (START).
If it is FALSE, machining is not interrupted at such a program point.
Description: FALSE:
If there is a preprocessing stop (either programmed or generated internally
by the control) before the deselection block (G40) when tool radius compensa-
tion is active, then firstly the starting point of the deselection block is
approached from the last end point before the preprocessing stop. The dese-
lection block itself is then executed, i.e. the deselection block is usually
replaced by two traversing blocks. Tool radius compensation is no longer
active in these blocks. The behavior is thus identical with that before the
introduction of this setting data.
TRUE:
If there is a preprocessing stop (either programmed or generated internally
by the control) before the deselection block (G40) when tool radius compensa-
tion is active, the end point of the deselection point is traversed in a
straight line from the last end point before the preprocessing stop.
42471 MIN_CURV_RADIUS EXP, C09 -
mm Minimum radius of curvature DOUBLE Immediately
-
808d-me42 - 3.0, 3.0, 3.0, 3.0, 3.0,
3.0, 3.0, 3.0...
0.0 - 0/0
808d-me62 - 1.0 0.0 - 2/2
808d-te42 - 3.0, 3.0, 3.0, 3.0, 3.0,
3.0, 3.0, 3.0...
0.0 - 0/0
808d-te62 - 3.0, 3.0, 3.0, 3.0, 3.0,
3.0, 3.0, 3.0...
0.0 - 0/0
42480 STOP_CUTCOM_STOPRE -W1
- Alarm response with tool radius compensation and preproc.
stop
BOOLEAN Immediately
-
- - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE...
0 - 3/3
42490 CUTCOM_G40_STOPRE -W1
- Retraction behavior of tool radius compensation with prep. stop BOOLEAN Immediately
-
- - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 3/3
Siemens Controls

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English