Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
319
NC setting data
Description: This setting data sets the following during JOG of circles:
Bit 0 = 0 :
Travel to + creates traversing on a circular path in counterclockwise direc-
tion; travel to - creates traversing in clockwise direction.
Bit 0 = 1 :
Travel to + creates traversing on a circular path in clockwise direction;
travel to - creates traversing in counterclockwise direction.
Bit 1 = 0 :
The tool radius is not taken into account in checking the limitation produced
by the specified circle or by the circle segment limited by the start and end
angles.
Bit 1 = 1 :
The tool radius is taken into account in checking the limitation produced by
the specified circle or by the circle segment limited by the start and end
angles.
Bit 2 = 0 :
Internal machining is performed. The circle radius in SD42691
$SC_JOG_CIRCLE_RADIUS is the maximum possible radius.
Bit 2 = 1 :
External machining is performed. The circle radius in SD42691
$SC_JOG_CIRCLE_RADIUS is the minimum possible radius.
Bit 3 = 0 :
Given a full circle, the radius is enlarged starting from the circle center
point in the direction of the ordinate (2nd geometry axis) of the plane.
Bit 3 = 1 :
Given a full circle, the radius is enlarged starting from the circle center
point in the direction of the abscissa (1st geometry axis) of the plane.
This setting data should be written via the user interface.
Description: This setting data defines the start angle during JOG of circles.
The start angle refers to the abscissa of the current plane. Traversing is
only possible within the range
between the start and the end angle. SD42692 $SC_JOG_CIRCLE_MODE bit 0
defines the direction from the start to the end angle. If start and end angle
equal zero, no limitation is active.
This setting data is written via the user interface.
42692 JOG_CIRCLE_MODE --
- JOG of circles mode DWORD Immediately
-
- - 0, 0, 0, 0, 0, 0, 0, 0... 0 0xf 2/2
42693 JOG_CIRCLE_START_ANGLE --
degrees Circle start angle DOUBLE Immediately
-
- - 0, 0, 0, 0, 0, 0, 0, 0... 0 360 2/2
Siemens Controls
To Next Page
Loading...
Need help?
General
