NC setting data
Parameter Manual
328
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
Reference point position for G30.1.
This setting data will be evaluated in CYCLE328.
Description: Position approached by the oscillating axis at the start of oscillation if
this is set in SD43770 $SA_OSCILL_CTRL_MASK.
Note:
MD 10710 $MN_PROG_SD_RESET_SAVE_TAB can be be set so that the value written
by the part program is transferred to the active file system on reset (that
is the value is retained after reset.)
43340 EXTERN_REF_POSITION_G30_1 -, A12 FBFA
- Reference point position for G30.1 DOUBLE Immediately
-
-- 0.0 - - 7/7
43790 OSCILL_START_POS --
mm, degrees Start position of reciprocating axis DOUBLE Immediately
-
808d-me42 - 0.0 - - 7/7
808d-me62 - 0.0 - - 7/7
808d-te42 - 0.0 - - 0/0
808d-te62 - 0.0 - - 0/0