\\?\Device\Harddisk0\Partition2
link to \\?\Device\HarddiskVolume2
\\?\Device\Harddisk0\Partition3
link to \\?\Device\HarddiskVolume3
\\?\Device\Harddisk1\Partition0
link to \\?\Device\Harddisk1\DR4
Removable media other than floppy. Block size = 512
size is 7780433920 bytes
\\?\Device\Harddisk1\Partition1
link to \\?\Device\HarddiskVolume7
Removable media other than floppy. Block size = 512
size is 7780433920 bytes
Virtual input devices
/dev/zero (null data)
/dev/random (pseudo-random data)
- (standard input)
Virtual output devices
- (standard output)
/dev/null (discard the data)
● Next step: Command
Note: Run the following lines as a command:
dd if=D:\temp\example-V2.2.0.wic of=\\?\Device
\Harddisk1\Partition0 bs=10M --progress
Error correction when the image is written to the SD card
If you expect problems when the image is written to the SD card:
● Disconnect the Internet connection.
● Stop the antivirus software.
A local security regulation can also hinder the execution of disk tools.
● Attempt to write the image to the SD card with a computer with less restrictive security
settings.
4.5.2 Infrastructure
Overview
This chapter provides notes and tips for the configuration of the IoT2040 in your network. The
Linux installation is largely identical. But some specific topics for the associated Yocto image
must be observed.
Installation/configuration
4.5 SIMATIC IoT2040
Manage MyMachines /Remote - installation in existing control environments
Application examples, 10/2018, A5E45211403B AB 39
To Next Page
Loading...
Need help?
General
