NCU 7x0.2
Manual, 02/2011, 6FC5397-0AP20-0BA0
37
Mounting
6
6.1 Safety information
NOTICE
The Control Unit is exclusively intended for installation in ESD-protected areas. The CE-
associated ESD interference immunity limit values can only be achieved via installation in
the control cabinet. Only make physical contact using appropriate ESD protective
measures.
Open equipment
These modules are open equipment. This means they may only be installed in housings,
cabinets or in electrical service rooms that can be entered or accessed exclusively by means
of a key or tool. Housings, cabinets, or electrical equipment rooms may only be accessed by
trained or authorized personnel. An external fire protection casing is required.
DANGER
The equipment must be deenergized when you mount the Control Unit.
Control cabinet installation
Please refer to the SINAMICS documentation for more details.
NOTICE
The 80 mm ventilation spaces above and below the Control Unit must be observed.
If you have any further questions or are looking for particular solutions, you can contact the
Systems Engineering Plant Chemnitz directly.
To Next Page
Loading...
Need help?
General
