Engineering and remote access
3.8 OPC UA server
SITOP UPS1600 / UPS1100
Manual, 04.2017, A5E37775406-8-76
173
ChargingCurrent
Float AnalogItemType Charge current
ChargeEndVoltage
Float AnalogItemType Battery voltage when charging changes to trickle charging.
Battery is charged 100 %.
AlarmInvalidSupply
Float AnalogItemType Alarm filter: an alarm is only sent if it is pending for longer
DeviceOutputEnable
Boolean PropertyType DeviceOutputEnableSetpoint
ResetEnableSetpoint Boolean PropertyType When input voltage returns during buffering, the output is
switched off for a configurable time in order to reset con-
ResetTimerSetpoint Byte AnalogItemType
Time for which the output of SITOP UPS1600 is switched off
when connected devices are reset.
ResistorTestInterval
Byte AnalogItemType Battery test interval
HardwareBattery
ProfileClamp
Enumeration MultiState
DiscreteType
The charge characteristic for batteries on signal terminals is
set. This setting is only applied if hardware settings are
HardwareBuffer
Enumeration MultiState
Trigger voltage for buffering - buffering is activated below
HardwareBuffer
Enumeration MultiState
Desired buffering time before device switches off
HardwareBuffering
Boolean PropertyType Enable buffering
HardwareEnable
ResetClamp
Boolean PropertyType When input voltage returns during buffering, the output is
switched off for a configurable time in order to reset con-
HardwareStartFrom
Boolean PropertyType Setting for 'Start from battery' on signal terminal
To Next Page
Loading...
Need help?
General
