SKGE 2000 C3
■ 8
│
GB│IE
Package contents and transport inspection
The appliance is supplied with the following components as standard
(see fold-out page):
● Contact grill
● Fat collector tray
● Cleaning scraper
● Operating instructions
NOTE
► Check the package for completeness and for signs of visible damage.
► If the delivery is incomplete or damage has occurred as a result of defective
packaging or during transport, contact the Service hotline (see chapter
entitled Service).
Unpacking
♦ Remove all parts of the appliance and the operating instructions from the
box.
♦ Remove all packaging materials and any films and labels.
Handling and operation
This section provides you with important information on handling and using the
appliance.
Before initial use
1) Clean all accessories as described in the section "Cleaning and care" to
remove any production residues.
2) Read these operating instructions carefully.
3) Install the appliance in accordance with the safety instructions.
4) Unlock the appliance by setting the safety catch 2 to the position
.
5) Open the appliance.
6) Wipe the hotplates 0 with a damp cloth.
7) Close the appliance.
8) Insert the power cable plug into a properly connected and earthed mains
power socket which supplies the voltage stated in the "Technical data" sec-
tion. Allow the appliance to heat up for about 5 minutes on the maximum
temperature setting by turning the heat level control 6 to MAX.
To Next Page
Loading...
Need help?
General
