PERSONAL SAFETY
SAFETY PRECAUTIONS
These Safety Precautions, Warnings and Cautions advise personnel of specific hazards
which may be encountered during the procedures contained in this document and that
control measures may be required to prevent injury to personnel, and damage to
equipment and/or the environment.
Before commencing the installation or any maintenance of the equipment covered in
this manual, personnel are to acquaint themselves with all risk assessments relevant
to the work site and the task. They must then comply with the control measures
detailed in those risk assessments.
References covering safety regulations, health hazards and hazardous substances are
detailed under the WARNINGS section below. These are referred to in the tasks, when
encountered.
Adequate precautions must be taken to ensure that other personnel do not activate
any equipment that has been switched off for maintenance. Refer to the relevant
Electrical Safety Regulations appropriate to the country of operation.
Where dangerous voltages are exposed during a task, safety personnel are to be
provided as detailed in the relevant Electrical Safety Regulations. Where safety
personnel are required for any other reason, management are to ensure that the
personnel detailed are aware of the hazard and are fully briefed on the action to be
taken in an emergency.
HAZARDOUS SUBSTANCES
Before using any hazardous substance or material, the user must be conversant with
the safety precautions and first aid instructions:
• On the label of the container in which it was supplied.
• On the material Safety Data Sheet.
• In any local Safety Orders and Regulations.
WARNINGS
RADIO FREQUENCY RADIATION (EU)
WARNING
RADIO FREQUENCY (RF) RADIATION. A RF RADIATION HAZARD EXISTS IN
THIS EQUIPMENT. TO AVOID RF INJURY, DO NOT TOUCH THE ANTENNA
WHEN THE TRANSMITTER IS IN USE. DO NOT OPERATE TRANSMITTER
WITH ANTENNA DISCONNECTED. REFER TO EU DIRECTIVE 2004/40/EC
Doc Number: TNM-U-E-0055 ISSUE 4.0 Page 10
To Next Page
Loading...
Need help?
General
