This function is unaffected by channel change.
7.8. MENU
The Menu function key is used for accessing the menu system and selects the first
main menu entry. This is normally assigned to the F1 key, labelled ‘M’.
7.9. MODE
This function is a short cut to the Mode menu. The Mode menu is used to change radio
modes, e.g. from P25 Conventional to MPT1327 Trunked.
Selections: Network 1-5. These networks may be PMR, MPT1327 Trunked, P25
Conventional or P25 Trunked.
Mode is supported in analogue and digital modes.
Once pressed, the radio screen will display the Network menu. The user can then use
the ▼ /▲ keys to select the network and then press OK. The screen will then return to
the channel screen of the new mode.
7.10. MUTE
This function is a shortcut to the Mute Adjust menu, which allows the radio Carrier-
Mute level to be adjusted.
Supported in analogue mode only. (Only applies to analogue channels).
On an analogue Channel, the mute level can be adjusted between the FPP Minimum
Mute and Maximum Mute limits.
7.11. RESET
The reset function performs several tasks.
In order of priority, it:
• Stops Alerts (if any Alerts are sounding).
• Performs a Backspace (if there is a User entry pending).
• Switches back to the Main Menu (if in a lower menu).
It is used during text entry modes such as Phonebook Edit and Text Messaging for
backspacing.
7.12. SCAN
The Scan key starts and stops the Scan mode on a channel that has been associated
with a scan list and enabled for scanning. Scanning will be indicated to the user with a
rotating arrow icon.
Doc Number: TNM-U-E-0055 ISSUE 4.0 Page 71
To Next Page
Loading...
Need help?
General
