›
To switch on/offin the main menu Navigation, tap on the function surface
→
Maršruto parinktys
→
Dinaminiai maršrutai
.
Eismo kliūties maršrute įvedimas arba pašalinimas rankiniu būdu
If a traffic obstruction is detected during route guidance (e.g. traffic jam), this
traffic obstruction be manually entered into the route.
After entering, Infotainment calculates and provides an alternative route.
Enter traffic obstruction
›
In the Navigation main menu, tap the function surface →
Spūstis priekyje
.
›
Adjust the length of the traffic obstruction.
The traffic obstruction will be displayed in red in the map to the right along the
route.
Remove traffic obstruction
The traffic obstruction is removed from the route after completion of the rou-
te guidance or can manually be removed as follows.
›
In the Navigation main menu, tap the function surface
→
Pašalinti „Spūstis prie-
kyje“
.
vehicle systems
CAR - Vehicle settings
Introduction to the subject
In the menu CAR travel data and information displayed on the vehicle and so-
me vehicle systems can be set.
Reset to factory settings
You can reset to factory settings in the Infotainment system in menu
/ →
→
Gamykliniai nustatymai
.
Nurodymas
Settings relating to the vehicle systems can only be made when the ignition is
switched on.
Main menu
pav. 242
Function surfaces in the main
menu
›
Tap on the button/sensor field
/
→ , parodomas pagrindinis meniu
su šiais funkciniais paviršiais » pav. 242.
Selecting the following menu points
▶
Skaitm. instrumentų pultas.
▶
Offroad
▶
Convenience consumers
▶
Driving data
▶
DriveGreen
▶
Vehicle status
Playback control - Radio / Media
200
Infotainment