HGM6100N Series Genset Controller User Manual Page 9 of 47
4 OPERATION
4.1 KEYS DESCRIPTION
Table 3 – Keys Description
Can stop generator under Manual/Auto mode;
Can reset shutdown alarm;
Press this key at least 3 seconds to test panel indicators are OK or not
(lamp test);
During stopping process, press this key again can stop generator
immediately.
Start genset under Manual mode; Press this key during starting process,
genset will jump to next status.
Pressing this key will set the module as Manual mode.
Pressing this key will set the module as Auto mode.
Can control gens to switch on or off in Manual mode.
Note: the key is fit for HGM6120 series controllers.
Can control gens to switch on in Manual mode.
Note: the key is fit for HGM6110 series controllers.
Can control gens to switch off in Manual mode.
Note: the key is fit for HGM6110 series controllers.
Press this key to enter menu interface;
Shift cursor to confirm in parameters setting menu.
Screen scroll;
Up cursor and increase value in setting menu.
Screen scroll;
Down cursor and decrease value in setting menu.
Return to homepage when in main interface;
Exit when in parameters setting interface.
To Next Page
Loading...
Need help?
General
