Hydro:Evolved Start-Up Guide
Jul 14, 2022 ©2022 Smartrise Engineering, Inc. All Rights Reserved Page 9
4.2 Relevel Offset
Relevel Offset is the distance from the destination position that the car cuts its leveling valve
when moving in the up or down direction on a releveling run.
Perform the following procedure to set the up or down offset.
Navigate to MAIN MENU | SETUP | HYDRO.
From the HYDRO SETUP menu, scroll and Relevel Offset Up or Down. The values are set
after determing how far the cars have overshot the landing.
From the RELEVEL OFFSET UP or RELEVEL OFFSET DOWN menu, enter the offset. The
values are set after determing how far the cars have overshot the landing.
Scroll right and press Save.
To Next Page
Loading...
Need help?
General
