Hydro:Evolved Start-Up Guide
Page 16 ©2022 Smartrise Engineering, Inc. All Rights Reserved Jul 14, 2022
8.2 Troubleshooting Adaptive Slowdown™ system (U.S. Patent
Pending)
The following steps are used to troubleshoot the car based on different occurrences:
• The car is overshooting the landing - Overshooting occurs if the leveling time is set too
short to allow for the weight fluctuation in slowdown distance, then car will take a
significant step back by increasing the slowdown distance. the Adaptive Slowdown™
system (U.S. Patent Pending) will decrease the distance until an overshoot occurs.
• Increase the Target Time in increments of .5 seconds and repeat step 4 of the
procedure.
• Car is taking too long arriving to the landing – The car will decrease the leveling time in
increments of .1 seconds based on the initial Hydro Speed Setup until the Target Time
on Adaptive Slowdown™ system (U.S. Patent Pending) is met and will continue to
fluctuate between the range. Decreasing the range will decrease the fluctuation of the
learning distance.
• Decrease the Target Time in increments of .5 seconds and repeat step 4 of the
procedure.
• The car is misaligned with the landing – The car is at the door zone, but slightly above
or below the landing.
• Follow instructions on the for Floor Adjustment to adjust the floor height to align
the car with the landing.
• Car is getting a TSRD fault when you are reaching the landing – Fault occurs when the
range of the TSRD distance to the landing is too high for the Slow Down Distance.
• Navigating to MAIN MENU | SETUP | HYDRO | TSRD DISTANCE
• Decrease the TSRD Distance to a lower value and repeat step 4 of the procedure.
To Next Page
Loading...
Need help?
General
