Hydro:Evolved Start-Up Guide
Page 20 ©2022 Smartrise Engineering, Inc. All Rights Reserved Jul 14, 2022
11 Outside of Dead Zone
The Dead Zone is the distance from which the car stops at either above or below the learned
position and inside the door zone that does not trigger releveling. If the car has a proper steady
state leveling time but still overshoots the learned floor position and stops outside the dead
zone and relevels, set the destination offset up or destination offset down depending on which
direction the car is moving.
Navigate to MAIN MENU | SETUP | HYDRO | HYDRO SPEED SETUP | DESTINATION
OFFSET UP and DESTINATION OFFSET DOWN.
Set the Destination Offset as follows:
If the car is moving in up direction and stops outside the dead zone, increase the
destination offset up by 0.5in.
If the car is moving in down direction and stops outside the dead zone, increase the
destination offset down by 0.5in.
This value also determines when to cut the low valves off and the sliding distance after the low
valves are cut.
To Next Page
Loading...
Need help?
General
